This article will introduce the method of saving cupronickel sax.

(1) Put the cupronickel sax in a clean place to avoid being stained with dust and difficult to wipe.
(2) Give cupronickel sax the last key oil in about a month, and the oil should not be too much, which will cause dirt. Apply some petroleum jelly on the cork mat of the cupronickel sax to avoid cracking.

(3) Always check whether the screws of the cupronickel sax are loose. If they are loose, they can be adjusted by yourself. Be careful not to tighten them too tightly to avoid the connecting rod being inflexible.

(4) After playing the cupronickel sax, remove the reed and put it in the reed holder to avoid deformation of the reed, and clean the mouthpiece at the same time.

(5) After each use of the cupronickel sax, wipe the instrument clean with a soft cloth. If the leather pad is wet, you can dry it with absorbent paper, otherwise, the pad will harden and damage.

(6) Handle with care. When holding the cupronickel sax, your hand should grasp the bell mouth, and do not grasp the part of the key, so as not to damage the connecting rod and the key.

(7) Do not put the cupronickel sax tube in a place where the temperature is too high, too cold and too humid.

(8) In winter, the hot air from playing the cupronickel sax will condense some water in the pipe. After blowing, pour the pipe mouth down, and then pierce it with a soft towel to try to dry it.

(9) Always wipe the fingerprints and sweat on the surface of the cupronickel sax tube with a cotton ball or a soft cloth.

Through the above introduction and analysis of cupronickel sax, hope it helps you.